Attribute	Value
Installation type	Wall Mounted
Input	AC 125V
Output	DC12V
Max Load	40W
Frequency	60Hz
Material	PC+ABS
Application	For LED Strip
Connection	Directly connect with LED Strip, no need driver

Working Principle & Dimming Technology

DC dimmers adjust light source brightness by modifying current or voltage, performing voltage conversion and stable current control. Two primary dimming technologies are employed:

PWM (Pulse Width Modulation): Adjusts LED brightness by altering duty cycle to control average current
Linear Dimming: Controls current through LED by modifying input voltage or current detection resistor resistance

Key Advantages

Flicker-free & Silent Operation: Advanced PWM technology eliminates flickering and reduces noise
High Efficiency: Exceptional reliability with extended operational lifespan
Multi-Channel Common Anode: Supports multiple LED lamp configurations
Precision Dimming: 0.1% adjustment accuracy for optimal lighting control

Application Scenarios

Indoor Lighting: Residential, office, and commercial spaces
Outdoor Lighting: Street, landscape, and public area illumination
Automotive Lighting: Vehicle interior and exterior lighting systems
Stage Lighting: Performance and event lighting solutions
Advertising Displays: LED billboards and informational displays
Smart Lighting: IoT-enabled lighting control systems

Installation:

Since it built in driver,the installation is very easy than normal dimmer switch, you needn't buy another LED driver any more.

• GND (GREEN): To ground wire in box.

• V+ (RED): To low voltage V+.

• V− (WHITE): To low voltage V−.

• N (WHITE): To 120 V Neutral.

• H (BLACK): To 120 V Line Hot.

TROUBLESHOOTING

1.Fixture does not illuminate

• Incorrect wiring. Polarity of Low Voltage V+ and V- are reversed.

• Circuit breaker is OFF or tripped.

• Incorrect voltage pairing of dimmer and fixture. 12 V dimmer models will not power a fixture with a higher voltage rating.

• Different fixtures do not dim in sync.

• Fixture turns off at low dim level.

• Fixture strobes/flickers at low dim level.

• Dimmer buzzes excessively

Only install 12 V or 24 VDC tape lights on the compatibility list.

3.Fixture heats up excessively

• Incorrect voltage pairing of dimmer and fixture. Do not attach a 12V fixture to a 24V dimmer.

• Fixture is not compatible.

Inquiry Cart 0